L6006a manual

(LA, LA) On existing installation, shut off the power and remove the old control. If the old immersion well appears suitable, and the adapter clamp on the Aquastat® Controller fits the old well spud, do not replace. 1. If the system is filled, drain system to a point below the boiler tapping. 2. Remove plug (or old well) from boiler. Summary of Contents of user manual for Honeywell L Page 1: Features L,7,8; L,7,8 Aquastat® Controllers PRODUCT DATA FEATURES FOR VERTICAL MOUNTING AND • L, 7, and 8 provide Spst switching for Page 2: Specifications L,7,8; L,7,8 AQUASTAT® CONTROLLERS SPECIFICATIONS IMPORTANT NOTE: The following specifications are. (LA, LA) On existing installation, shut off the power and remove the old control. If the old immersion well appears suitable, and the adapter clamp on the Aquastat ® Controller fits the old well spud, do not replace. 1. If the system is filled, drain system to a point below the boiler tapping.

Manual Reset When the device includes manual reset (LE and H), be sure to press the red reset button on the front of the case to make sure that the controller is not locked out on safety. When checking out the system, adjust the control point low enough so the temperature of the controlled medium reaches the high limit setting, the burner shuts. be used and connected to supply end of largest system zone, Also, a manual by-pass valve 'D' should be installed in case of zone valve (2) failure. CONTROL OPERATION OF WOOD/COAL ADD-ON BOILER LA I V The LA is the operating control on the add_on boiler. A manuai switch activates the control once. User manual | HONEYWELL LA AQUASTAT Installation Operating Instructions The LA is designed for horizontal or vertical insertion/mounting using an immersion well (not included). Refer to Wells and Fittings for Temperature Controllers, form , for part numbers and ordering information. A package of heat-conductive compound is.

Manual reset Horizontal or vertical Breaks Š TRADELINE model available. Š Insulation depth /2 in. or 3 in. (38 or 76 mm). Š NPT brass spud 1/2 in. (13 mm) Š Factory-set stop at ° F (° C). Š Capillary 8 in. ( mm). a Some models include copper well or fitting; specify when ordering. Also specify boiler tapping size 1/2 or 3/4 in. Manual reset Horizontal or vertical Breaks Š TRADELINE model availiable. Š Insulation depth /2 or 3 in. (38 or 76 mm). Š NPT brass spud 1/2 in. Š Factory-set stop at °F (°C). Š Capillary 8 in. ( mm). LG High limit and circulator control ° to °F (38° to 93°C) 10°F (6°C) fixed Horizontal Two switches break. (LA, LA) On existing installation, shut off the power and remove the old control. If the old immersion well appears suitable, and the adapter clamp on the Aquastat® Controller fits the old well spud, do not replace. 1. If the system is filled, drain system to a point below the boiler tapping. 2. Remove plug (or old well) from boiler.